For the complete documentation index, see llms.txt. This page is also available as Markdown.

Material Info Setup

The Material Info Setup section allows users to define the desired order of material parameters in the desired way (e.g. "Material Id", "Material group", "Material Status", "Material version", "Compliance information", etc).

To define the order of material information, users should use the arrows located on the right side of each available material parameter. After selecting the desired order, click the "Save" button to apply the changes. The selected material parameter order will be used across all locations where material information is displayed.

Figure 1: Screenshot of Material Info Setup in Data Maintenance section
Figure 2: Screenshot showing the applied Material Info Setup for a polymer material "Vectra E130i"

Last updated

Was this helpful?